Boo Y'all HTV Transfer (Various Sizes, see drop down!)

Lor's Transfer Deals

$5.00

Shipping calculated at checkout

Available Now!

5 Inches Wide
7.5 Inches Wide
10.5 Inches Wide
12.5 Inches Wide

THIS IS NOT A DIGITAL FILE.

THIS IS AN HTV TRANSFER

YOU WILL GET ONE MASK PER 4 HTV TRANSFERS THAT ARE ORDERED - EACH MASK CAN BE USED 3-4 TIMES!

SIZING:

The sizing for these transfers are measured in WIDITH - the length is determined by how the design naturally falls to prevent the design from looking stretched etc.

 

DISCLAIMER:

Each order will come with directions they are also posted on the site. It is your responsibility as the buyer to know your machine and have the proper materials. Also please note, due to the settings of each individual’s monitor the colors sometimes vary in the printed version. With this being said, the colors might look slightly different between the listing and the physical item. Once these are purchased I am not responsible for user error etc. these are non-refundable. Purchasing this item means you agree to the terms and conditions.

 

MADE TO ORDER:

These are made to order so go along with the normal processing of the website.


APPLICATION DIRECTIONS:

Apply the mask with a squeegee to put over the design and pull it from the backer.

Apply Design at 310 Degrees (F) for 15 seconds with medium pressure Peel mask from design while HOT

It is my recommendation to use a Teflon piece to protect your heat press.

It is also my recommendation to peel a corner of the design to make sure it adhered to the shirt.

Every heat press runs differently and yours might run slightly under temperature etc.

I DO recommend to wait 24 hours before washing the garment the HTV transfer was adhered to!

 

MATERIAL CAPABILITY:

100% Cotton

100% Polyester

Cotton/Poly Blends

Spandex blends

 

CARE INSTRUCTIONS:

Hand wash - Inside out Mild Detergent

DO NOT Use Bleach or Fabric Softener

Hang Dry Only

DO NOT Use Household Iron or Dry Clean


CAN I USE A HOUSE HOLD IRON?

CAN I USE A CRICUT EASY PRESS?

The answer to both of these common questions is YES you can, I don't recommend it because it is much harder to control the pressure. It can be done though, just make sure when using your Iron you're not using the steam mode and you put a Teflon piece over the design to protect both the design and your iron/Easy Press.